Switch PoE 6Port WLAN Extend (4Port PoE, max30W/port), lighting protection 65W POE intern, softstart PD, sequential boot-up

Netis

P106C

Nou

Netis P106C is a 100M standard POE switch that provides 6*10/100M adaptive RJ45 ports. Ports 1~4 features POE power supply capability and can be used as Power over Ethernet devices.

Detalii

125,97 Lei fara TVA
149,90 Lei cu TVA

Detalii

• Supporting 802.3 Ethernet, 802.u Faster Ethernet;
• Supports POE IEEE 802.3af/at compliant Powered Device (PD)
• Modes: Normal switch mode/Extended mode(Port1-4:250Metres ultra-long
transmission)
• Ports 1~4 features POE power supply capability and can be used as Power over
Ethernet devices;
• Auto MDI/MDIX crossover for all ports
• Support full duplex based on IEEE802.3x and half duplex based on Backpressure
• Support non-blocking wire speed forwarding
• MAC address auto-learning & auto-aging
• Steel case,the total POE power budget of 65 W
• Plug and play
Hardware
Interface

4×10/100Mbps POE ports(Data/Power)

2×10/100Mbps POE ports(Data/Power)

 Basic function

 Follow IEEE 802.3 Ethernet and IEEE802.3u Fast Ethernet Protocol

 Supports POE IEEE 802. 3af/at compliant Powered Device (PD)
 Store-and-forward switching scheme
 Support IEEE802.3X full duplex and Backpressure half duplex
 MAC address auto-learning & auto-aging
 Standards

 IEEE 802.3 10BASE-T Ethernet

 IEEE 802.3i 10BASE-T Ethernet
 IEEE 802.3u 100BASE-TX Fast Ethernet
 IEEE 802.3af/at, Power over Ethernet
 IEEE 802.3x Flow Control
 Mode
 Normal switch mode/Extend mode
 Data Transfer Rate

Etherent:10Mbps(Half-duplex);20Mbps(Full-duplex)

Fast Entherent:100Mbps(Half-duplex);200Mbps(Full-duplex)

 Store & Forwarding
Yes
 Switching Capacity
1.2G
 MAC Address
  Table Size
2K
 Jumbo Frame
 2048 byte
 Environment
 Operation Temperature:0℃~40℃
 Storage Temperature:-40℃~70℃
 Operation Humidity:10%~90% RH Non-condensing
 Storage Humidity:5%~90% RH Non-condensing
 Power Input POE
 Standards
 Single port maximum power 30W,

 Whole switch maximum power 58W

 Support over-current,over-voltage and short-circuit protection

 Support Soft Start of High  Power PD

 Support sequential boot-up
 Power Supply Pin:12+/36-
 AC 110~240V 50/60HZ
 Cabling type
 100Base-TX: Cat 5e or better UTP/STP(≤100m)

 10Base-TX: Cat 5e or better UTP/STP(≤250m)
Dimensions
(L x W x H )
 124mm*115mm*33mm